HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)

Configuring a Standard Data Replication Manager Solution
126 Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
Configure the SWCC Agent (Optional)
I You may now install and configure the SWCC Agent. Refer to the HP StorageWorks HSG80
ACS Solution Software Version 8.7 for HP-UX Installation and Configuration Guide for
installation instructions.
Additional Setup
I You may now configure volume groups, logical volumes, and file systems on any nonremote
copy set LUNs on the storage arrays using normal HP-UX procedures.
Your HP-UX host is now configured to use DRM. Repeat this procedure for each HP-UX host
present at your initiator site. After configuring the initiator site hosts, go to the section titled
“Additional Host Configuration,” on page 144.
IBM AIX
Before beginning this procedure, make sure that your host is up to date with service packs and
patches. For supported revision levels, refer to the DRM Release Notes.
Install the HBAs
I You must install at least two HBAs in each host system. HBAs must be installed in pairs. You
may install a maximum of six adapters per host, but two adapter pairs must not share the same
unit on the RAID system.
Power down your AIX host and install the HBAs in any of the free PCI slots. The HBAs work
in either a 32-bit or 64-bit PCI card slot. Record the HBA WWID for use later in this section.
Note: Do not attach your fiber connections to the HBAs at this time and do not install the AIX driver
that comes with the Cambex HBA. The driver is installed in the following step.
Install the Secure Path Fibre Channel HBA Driver and the AIX Platform Kit
I The following describes the preferred method for installing the StorageWorks platform kit
software for IBM AIX and Secure Path Fibre Channel HBA device driver software on your
AIX servers. Use these instructions, in the given order, instead of the installation instructions
in the platform kit (HP StorageWorks HSG80 ACS Version 8.7 Solution Software for IBM AIX
Installation and Configuration Guide) and Secure Path software (HP StorageWorks Secure
Path for IBM AIX Installation and Reference Guide).
I New Installation
Follow these instructions if you are performing a new installation of the HP StorageWorks
platform kit for AIX and Secure Path.
I New Installation Assumptions
■ All components are not connected.
■ AIX operating system version is v4.3.3 or v5.1
■ Cambex is the Fibre Channel adapter.
■ Latest version of Secure Path software.
■ Solution platform kit is v8.7.