HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)

Configuring a Standard Data Replication Manager Solution
127Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
■ HSG80 ACS code is v8.7P.
■ Storage subsystem is pre-configured with or without a CCL LUN.
■ Mode is SCSI-2 or SCSI-3, with the LUN connection type set as WINNT.
■ HBAs are installed in pairs.
■ No volume groups, logical volumes, or file systems are created.
■ Clustering services is not installed.
HBA Limitations
HBAs have the following limitations:
■ Addressing of LUNS is limited to 16 devices. This limitation must be considered when
planning the subsystem storage configuration.
■ Configuring a CCL LUN will leave 15 LUN addresses.
Installation Steps
I 1. Install Fibre Channel HBAs. Do not connect fiber cables at this time.
Note: The maximum number of HBAs per host is 6. Refer to IBM's PCI Adapter Placement
Reference document.
I 2. Power up or boot server.
I 3. Load the HP StorageWorks HSG80 ACS Version 8.7 platform kit for AIX:
a. Load platform CD into CD drive.
b. Enter the following commands:
#mkdir /cdrom
#mount -v cdrfs -r /dev/cd0 /cdrom
#cd /cdrom
#./INSTALL
(follow the prompts)
The system will not find any DEC HSG80 RAID array devices at this time.
The option of installing the SWCC Agent will be presented at this time. Choose Yes.
Installation of the SWCC Agent will begin. When installation is complete, you will be
asked if you wish to start the Agent:
■ Answer Yes if the host will be used as an SWCC Agent.
■ Answer No if the host will not be used as an SWCC Agent.
Refer to the HP StorageWorks HSG80 ACS Solution Software Version 8.7 for IBM
AIX Installation and Configuration Guide for additional information on this process.
#umount /cdrom
I 4. Remove platform kit Fibre Channel driver with the following commands:
#installp -u PC1000.driver.obj
#lslpp -l PC1000.driver.obj