HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)

Configuring a Standard Data Replication Manager Solution
136 Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
I 2. When you have completed the worksheet, rename the connections:
RENAME !NEWCONxx TargetHostConnectionNamex
RENAME !NEWCONxx TargetHostConnectionNamey
Example: rename !NEWCONxx HostA1
Example: rename !NEWCONxx HostA2
I 3. Set the operating system for each connection to Windows:
SET TargetHostConnectionNamex OPERATING_SYSTEM = WINNT
Example: set HostA1 operating_system = winnt
Example: set HostA2 operating_system = winnt
I 4. When you have finished renaming your host connections, verify your new settings:
SHOW CONNECTIONS
You should see a display similar to that in Example Display 47.
Example Display 47
Connection Unit
Name Operating system Controller Port Address Status Offset
BUILDNGBA PPRC_TARGET THIS 2 online 0
HOST_ID=nnnn-nnnn-nnnn-nnnn ADAPTER_ID=nnnn-nnnn-nnnn-nnnn
BUILDNGBB PPRC_TARGET OTHER 2 . . . . . . . . . . . online 0
HOST_ID=nnnn-nnnn-nnnn-nnnn ADAPTER_ID=nnnn-nnnn-nnnn-nnnn
BUILDNGBC PPRC_INITIATOR THIS 2 . . . . . . . . . . . online 0
HOST_ID=nnnn-nnnn-nnnn-nnnn ADAPTER_ID=nnnn-nnnn-nnnn-nnnn
BUILDNGBD PPRC_INITIATOR OTHER 2 . . . . . . . . . . . online 0
HOST_ID=nnnn-nnnn-nnnn-nnnn ADAPTER_ID=nnnn-nnnn-nnnn-nnnn
HOSTA1 WINNT THIS 1 210013 online 0
HOST_ID=nnnn-nnnn-nnnn-nnnn ADAPTER_ID=nnnn-nnnn-nnnn-nnnn
HOSTA2 WINNT OTHER 1 200113 online 0
HOST_ID=nnnn-nnnn-nnnn-nnnn ADAPTER_ID=nnnn-nnnn-nnnn-nnnn
.
.
.
Update Switch Zones
The switch zones created at the target site must be updated with the host connection
information (refer to Chapter 6, “Configuring the Optional Advanced DRM Solutions,” for
detailed information on zone creation and updating switch zones):
I 1. On the top fabric, add the host connection to the zone that contains port 1 of the top
initiator controller.
I 2. On the bottom fabric, add the host connection to the zone that contains port 1 of the
bottom initiator controller.
Your Windows host is now configured to use DRM. Execute this procedure for each Windows
host present at the initiator site. After configuring the initiator site hosts, go to the section titled
“Additional Host Configuration,” on page 144.