HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)

Configuring a Standard Data Replication Manager Solution
137Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
Novell NetWare
I
Before beginning this procedure, make sure that your host is up to date with support packs and
patches. For supported revision levels, refer to the DRM Release Notes.
Install the HBAs
I You must install at least two HBAs in each host system. Record the HBA WWID for use later
in this section. Refer to the Compaq StorageWorks 64-Bit PCI-to-Fibre Channel Host Bus
Adapter User Guide for installation instructions. The user guide is located at:
http://h18004.www1.hp.com/products/storageworks/techdoc/adapters/AA-RKPDB-TE.html.
Note: Do not attach your fiber connections to the HBAs until instructed to do so. The driver is
installed in the following step.
Install the HBA Driver
I The NetWare HBA multipath driver is CPQFC.HAM. The driver is installed as part of the
Secure Path Agent installation. Refer to the next section.
Install Secure Path Agent
For installation instructions, refer to the current version of the HP StorageWorks Secure Path
Version for Novell NetWare Installation and Reference Guide. After installation, execute the
following procedure:
I 1. Verify that the Secure Path Agent is installed by typing the following at the server console:
modules cpqspagt
If the agent has installed properly, you will see a display of version information.
Ensure that the Secure Path Agent is set for automatic startup. Normally, the Secure Path
installation program sets automatic startup by loading cpqspagt.nlm in the autoexec.ncf
file.
I 2. Use the Secure Path Agent Configuration screen at the server to grant access to the client
at both the initiator and target sites. To do this:
a. From the NetWare server, toggle to the Secure Path NLM (NetWare Loadable
Module) screen.
b. At the Main menu, select 2) Client Administration, then select 2) Add a Client.
c. Type the fully qualified DNS name for the client, then press Enter.
d. Press Esc to return to the Main menu.
I 3. To set the password and allow client access via the Secure Path Agent Configuration,
execute the following procedure:
a. At the Main menu, select 1) Agent Administration, then select 1) Change
Password.
b. Type a password for client access and then retype the password for verification.
c. Press Esc to return to the Main menu.