HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)

Configuring a Standard Data Replication Manager Solution
143Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
Example Display 51
Connection Unit
Name Operating system Controller Port Address Status Offset
HOSTA1 SUN THIS 1 210013 online 0
HOST_ID=nnnn-nnnn-nnnn-nnnn ADAPTER_ID=nnnn-nnnn-nnnn-nnnn
HOSTA2 SUN OTHER 1 200113 online 0
HOST_ID=nnnn-nnnn-nnnn-nnnn ADAPTER_ID=nnnn-nnnn-nnnn-nnnn
.
.
.
Update Switch Zones
The switch zones created at the target site must be updated with the host connection
information (refer to Chapter 6, “Configuring the Optional Advanced DRM Solutions,” for
detailed information on updating switch zones):
I 1. On the top fabric, add the host connection to the zone that contains port 1 of the top
initiator controller.
I 2. On the bottom fabric, add the host connection to the zone that contains port 1 of the
bottom initiator controller.
Enable Access to the Hosts at the Initiator Site
I The initiator units must have access to the hosts. Enable access with the following command:
SET UnitName ENABLE_ACCESS_PATH=InitiatorHostConnectionNamex,
InitiatorHostConnectionNamey
Example: set UnitName enable_access_path=HostA1,HostA2
Repeat this step for all units.
Verify the Disks
To run DRM, you must have an even number of HBAs installed in each host system. Follow
the procedures below:
I 1. Reboot the host using the reboot -- -r command.
I 2. Issue the format command to verify that disks are present.
Note: There are two entries for each disk, one per HBA. After installing Secure Path for Solaris,
there will be only
one entry per disk.
Install Secure Path for Solaris Software
I Install the Secure Path software as specified in the current version of the HP StorageWorks
Secure Path for Sun Solaris Installation and Reference Guide.
Configure Secure Path with the following command:
/opt/CPQswsp/bin/spconfig -o -p /kernel/drv
After installing Secure Path, reboot the host using the reboot -- -r command.