HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)
57Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
4
Configuring a Standard Data
Replication Manager Solution
This chapter provides procedures for configuring your Data Replication Manager (DRM)
solution. Because a DRM system spans two sites, you must configure the DRM system at each
site.
These procedures take you through the configuration process. You will first set up the target
site, then the initiator site. Setup for each site is similar. At each site, you will configure the
controllers by defining controller characteristics specific to DRM. You will then define
storagesets, units, remote copy sets, and association sets. After the controllers are configured,
you will make fiber optic cable connections between the controllers and switches. Finally, you
will install the necessary software and drivers on each host.
This chapter covers the following topics:
■ Introduction‚ page 58
■ Configuration Overview‚ page 60
■ Configure the Controllers at the Target Site‚ page 62
■ Configure Storage at the Target Site‚ page 69
■ Cable the Target Site‚ page 71
■ Create Switch Zones at the Target Site‚ page 74
■ Configure the Host at the Target Site‚ page 74
■ Configure the Controllers at the Initiator Site‚ page 100
■ Configure Storage at the Initiator Site‚ page 107
■ Cable the Initiator Site‚ page 109
■ Connect the Initiator Site to the External Fiber Link‚ page 111
■ Create Switch Zones‚ page 112
— Create Connections from the Target Site‚ page 112
■ Create Write History Log Units and Association Sets (Optional)‚ page 115
■ Configure the Host at the Initiator Site‚ page 118
■ Additional Host Configuration‚ page 144
■ Documenting Your Configuration‚ page 145