HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)

Configuring a Standard Data Replication Manager Solution
74 Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
Create Switch Zones at the Target Site
You must now create zones on the switches that the controllers are connected to. See
Chapter 6, “Configuring the Optional Advanced DRM Solutions,” for more information on
creating zones.
T 1. Create a zone on the top fabric that contains port 1 of the top controller. This zone will
later contain target host connections as well.
T 2. Create a zone on the top fabric that contains port 2 of the top controller. This zone will be
the top ISL zone.
T 3. Create a zone on the bottom fabric that contains port 1 of the bottom controller. This zone
will later contain target host connections as well.
T 4. Create a zone on the bottom fabric that contains port 2 of the bottom controller. This zone
will be the bottom ISL zone.
There must be four zones when you are finished (two per fabric).
Configure the Host at the Target Site
This section describes how to set up your host systems at the target site. Follow the procedures
for each operating system in your SAN. Execute the appropriate procedure for each of your
operating systems:
■ HP OpenVMS, page 74
■ HP Tru64 UNIX, page 77
■ HP-UX, page 80
■ IBM AIX, page 82
■ Microsoft Windows NT and Windows 2000, page 90
■ Novell NetWare, page 93
■ Sun Solaris, page 96
HP OpenVMS
Before beginning this procedure, make sure that your host is up to date with service packs and
patches. For supported revision levels, refer to the DRM Release Notes.
Install the HBAs
T You must install at least two HBAs in each host system. Record the HBA World Wide ID
(WWID) for use later in this section. Refer to the Compaq StorageWorks 64-Bit PCI-to-Fibre
Channel Host Bus Adapter User Guide for installation instructions. The user guide is located
at:
http://h18004.www1.hp.com/products/storageworks/techdoc/adapters/AA-RKPDB-TE.html.
Note: Do not attach your fiber connections to the HBAs until instructed to do so.