HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)

Configuring a Standard Data Replication Manager Solution
78 Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
Example Display 13
Apr 19 14:19:37 tru002 vmunix: KGPSA-CA : Driver Rev 1.30:
F/W Rev 3.81A4(2.01A0): wwn 1000-0000-c924-fe8c
Multipath Software
Tru64 UNIX has native multipath support with path auto-detection. No further configuration is
required.
Install SWCC (Optional)
T You may now install SWCC. For detailed information about SWCC, including installation,
refer to the Compaq StorageWorks Command Console Version 2.4 User Guide.
Connect the Host to the SAN
Use your established cabling policy to connect the host to the Fibre Channel switch.
T 1. Use 50-micron, multimode fiber optic cable to connect one adapter of each pair to the top
Fibre Channel switch.
T 2. Use 50-micron, multimode fiber optic cable to connect the other adapter of each pair to the
bottom Fibre Channel switch.
For example, if there are four adapters in a server, the first and third adapters must be
connected to the top Fibre Channel switch and the second and fourth adapters must be
connected to the bottom Fibre Channel switch.
T 3. Verify that the connection between the host and the switch has been made:
SHOW CONNECTIONS
You should see a display similar to that in Example Display 14.
Example Display 14
Connection Unit
Name Operating system Controller Port Address Status Offset
!NEWCON00 WINNT THIS 1 210013 online 0
HOST_ID=nnnn-nnnn-nnnn-nnnn . . . . ADAPTER_ID=nnnn-nnnn-nnnn-nnnn
!NEWCON01 WINNT OTHER 1 200013 online 0
HOST_ID=nnnn-nnnn-nnnn-nnnn . . . . ADAPTER_ID=nnnn-nnnn-nnnn-nnnn
Rename the Host Connections
To better identify which hosts you are working with, HP recommends that you rename the host
connections, using a meaningful connection name for each. Each HBA appears as a
connection. An HBA can be identified by its WWN, which you recorded when you installed
the HBAs, and which appears in the connection description.
Initially, each connection is named !NEWCONxx. It is much easier to track connections if the
connection names are meaningful, like “HostB1.”