HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)

Configuring a Standard Data Replication Manager Solution
90 Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
Note: In the example, hdisk2 represents a nonremote copy set because you have disabled
access to all RCS LUNs.
Configure the SWCC Agent (Optional)
T The SWCC Agent may now be installed and configured. Refer to the HP StorageWorks
HSG80 ACS Solution Software Version 8.7 for IBM AIX Installation and Configuration Guide
for installation instructions.
Additional Setup
T You may now configure volume groups, logical volumes, and file systems on any nonremote
copy set LUNs on the storage arrays using normal AIX procedures.
Your AIX host is now configured to use DRM. Repeat this procedure for each AIX host
present at your target site. After configuring the target site hosts, go to the section titled
“Configure the Controllers at the Initiator Site” on page 100.
Microsoft Windows NT and Windows 2000
Before beginning this procedure, make sure that your host is up to date with service packs and
patches. For supported revision levels, refer to the DRM Release Notes.
Make sure that the hosts are not connected to the Fibre Channel switches during this
procedure.
Install the HBAs and Update Firmware
T You must install at least two HBAs in each host system. HBAs must be installed in pairs.
Refer to the Compaq StorageWorks 64-Bit PCI-to-Fibre Channel Host Bus Adapter User
Guide for installation instructions. The user guide is located at:
http://h18004.www1.hp.com/products/storageworks/techdoc/adapters/AA-RKPDB-TE.html.
Note: Do not attach your fiber connections to the HBAs at this time. The driver is installed in the
following step.
Install the HBA Driver
T Use the Device Manager to install the HBA driver. For updated driver version information,
refer to the DRM Release Notes.
Install Fibre Channel Software
T Install the HP Fibre Channel software on the host. For updated Fibre Channel software version
information, refer to the DRM Release Notes.