HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)

Configuring a Standard Data Replication Manager Solution
93Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
Update Switch Zones
The switch zones created earlier must be updated with the host connection information (refer
to Chapter 6, “Configuring the Optional Advanced DRM Solutions,” for detailed information
on zone creation):
T 1. On the top fabric, add the host connection to the zone that contains port 1 of the top target
controller.
T 2. On the bottom fabric, add the host connection to the zone that contains port 1 of the
bottom target controller.
Your Windows host is now configured to use DRM. Execute this procedure for each Windows
host present at the target site. After configuring the target site hosts, go to the section titled
“Configure the Controllers at the Initiator Site” on page 100.
Novell NetWare
Before beginning this procedure, make sure that your host is up to date with support packs and
patches. For supported revision levels, refer to the DRM Release Notes.
Install the HBAs
T You must install at least two HBAs in each host system. Record the HBA WWID for use later
in this section. Refer to the Compaq StorageWorks 64-Bit PCI-to-Fibre Channel Host Bus
Adapter User Guide for installation instructions. The user guide is located at:
http://h18004.www1.hp.com/products/storageworks/techdoc/adapters/AA-RKPDB-TE.html.
Note: Do not attach your fiber connections to the HBAs until instructed to do so. The driver is
installed in the following step.
Install the HBA Driver
T The NetWare HBA multipath driver is CPQFC.HAM. The driver is installed as part of the
Secure Path Agent installation.
Install Secure Path Agent
For installation instructions, refer to the current version of the HP StorageWorks Secure Path
for Novell NetWare Installation and Reference Guide located at
http://h18006.www1.hp.com/products/sanworks/secure-path/index.html.
After installation, execute the following procedure:
T 1. Verify that the Secure Path Agent is installed by typing the following at the server
console:
modules cpqspagt
If the agent has installed properly, you will see a display of version information.
Ensure that the Secure Path Agent is set for automatic startup. Normally, the Secure Path
installation program sets automatic startup by loading cpqspagt.nlm in the autoexec.ncf
file.