HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)

Configuring a Standard Data Replication Manager Solution
99Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
Enable Access to the Hosts at the Target Site
T The target units must have access to the hosts before configuring Secure Path. Enable access
by issuing the following command:
SET UnitName ENABLE_ACCESS_PATH = TargetHostConnectionNamex,
TargetHostConnectionNamey
Example: set UnitName enable_access_path = HostB1,HostB2
Verify the Disks
To run DRM, you must have an even number of HBAs installed in each host system. Follow
the procedures outlined here.
T 1. Reboot the host using the reboot -- –r command.
T 2. Issue the format command to verify that the disks are present.
Note: There are two entries for each disk, one per HBA. After installing Secure Path for Solaris,
there will be only
one entry per disk.
Install Secure Path for Solaris Software
T Install the Secure Path software as specified in the current version of the HP StorageWorks
Secure Path for Sun Solaris Installation and Reference Guide
available at
http://h18006.www1.hp.com/products/sanworks/secure-path/index.html.
After configuring Secure Path, reboot the host using the reboot -- –r command.
Reverify the Disks
T Issue the format command again to verify that disks are present. There must be only one
entry for each disk.
Note: All target numbers are stored in IdLite.conf .
Configure SWCC Agent (Optional)
T You may now configure SWCC. Refer to the HP StorageWorks HSG80 ACS Solution
Software Version 8.7 for Sun Solaris Installation and Configuration Guide for details on the
Configuration utility. Invoke the Configuration utility with the command:
/opt/steam/bin/install.h