HP StorageWorks Enterprise File Services WAN Accelerator 2.1.5 deployment guide (June 2006)

104 9 - RADIUS AND TACACS+ AUTHENTICATION
Basic Steps The following section describes the basic steps for configuring TACACS+
authentication in the HP EFS WAN Accelerator.
1. Configure the HP EFS WAN Accelerator. For detailed information, see the HP
StorageWorks Enterprise File Services WAN Accelerator Installation and
Configuration Guide.
2. Connect to the Management Console. For detailed information, see the HP
StorageWorks Enterprise File Services WAN Accelerator Installation and
Configuration Guide.
3. Navigate to the Setup: Authentication - General Settings page in the Management
Console.
4. Define the authentication methods. Make sure you put the authentication methods
in the order in which you want them to occur. If authorization fails on the first
method, the next method is attempted, and so forth, until all the methods have been
attempted.
Figure 9-3. Setup: Authentication - General Settings Page