HP StorageWorks Enterprise File Services WAN Accelerator 2.1.5 deployment guide (June 2006)

ManualsBrandsHP ManualsComputer AccessoriesHP StorageWorks Enterprise File Services (EFS) DL320-1020 WAN Accelerator

111

112

113

114

115

116

117

118

119

120

110 10 - SERIAL CLUSTER AND CASCADE DEPLOYMENTS

To configure HP EFS

WAN Accelerator2

1. On HP EFS WAN Accelerator2, connect to the CLI. For detailed information, see

the HP StorageWorks Enterprise File Services WAN Accelerator Command-Line

Interface Reference Manual.

2. At the system prompt, enter the following set of commands:

SH2 > enable

SH2 # configure terminal

SH2 (config) # in-path peering rule pass peer 10.0.1.1 rulenum 1

SH2 (config) # in-path peering rule pass peer 10.0.1.3 rulenum 1

SH2 (config) # in-path rule pass-through srcaddr 10.0.1.1/32 rulenum 1

SH2 (config) # in-path rule pass-through srcaddr 10.0.1.3/32 rulenum 1

SH2 (config) # wr mem

SH2 (config) # show in-path peering rules

Rule Type Source Network Dest Network Port Peer Addr

----- ------ ------------------ ------------------ ----- --------------

1 pass * * * 10.0.1.3

2 pass * * * 10.0.1.1

def auto * * * *

SH1 (config) # show in-path rules

Rule Type Source Addr Dest Addr Port Target Addr

Port

----- ---- ------------------ ------------------ ----- ---------------

-----

1 pass 10.0.1.3/32 * * -- --

2 pass 10.0.1.1/32 * * -- --

def auto * * * -- --

To configure HP EFS

WAN Accelerator3

1. On HP EFS WAN Accelerator3, connect to the CLI. For detailed information, see

the HP StorageWorks Enterprise File Services WAN Accelerator Command-Line

Interface Reference Manual.

2. At the system prompt, enter the following set of commands:

SH3 > enable

SH3 # configure terminal

SH3 (config) # in-path peering rule pass peer 10.0.1.1 rulenum 1

SH3 (config) # in-path peering rule pass peer 10.0.1.2 rulenum 1

SH3 (config) # in-path rule pass-through srcaddr 10.0.1.1/32 rulenum 1

SH3 (config) # in-path rule pass-through srcaddr 10.0.1.2/32 rulenum 1

SH3 (config) # wr mem

SH3 (config) # show in-path peering rules