HP StorageWorks Enterprise File Services WAN Accelerator 2.1.5 deployment guide (June 2006)

HP STORAGEWORKS ENTERPRISE FILE SERVICES WAN ACCELERATOR 2.1.5 DEPLOYMENT GUIDE 37

4 - OUT-OF-PATH NETWORK

EPLOYMENTS

 Type the IP address and port for the destination subnet, in the Destination

Subnet and Port text boxes. To specify all ports, type all in the Port text box.

 Under Targets, type the IP address and port number for the HP EFS WAN

Accelerator that is the peer in the Target Appliance IP and Port text boxes.

The IP address must be the Primary Port IP address on the target HP EFS WAN

Accelerator. The default port is 7810.

 If you have a backup, out-of-path HP EFS WAN Accelerator in your system

(failover support), type the IP address and port for the backup appliance in the

Backup Appliance IP and Port text boxes. Use the following format: 0.0.0.0/

0. The default port is 7810.

5. Apply and save the new configuration in the Management Console.

6. Begin optimization. View performance reports and system logs in the

Management Console.

Basic Steps

(Server-Side)

The server-side HP EFS WAN Accelerator is configured as an out-of-path device. For

detailed information, see the HP StorageWorks Enterprise File Services WAN

Accelerator Installation and Configuration Guide.

1. Navigate to the Setup: Optimization Service - General Settings page in the

Management Console.

2. Enable out-of path support click Enable Out-of-Path Support.

Figure 4-8. Setup: Optimization Service - General Settings Page