HP StorageWorks Enterprise File Services WAN Accelerator 2.1.5 deployment guide (June 2006)

70 7 - WCCP DEPLOYMENTS
client-SH (config) # in-path rule fixed-target port 135 target-addr
10.2.0.2
client-SH (config) # in-path rule fixed-target port 139 target-addr
10.2.0.2
client-SH (config) # in-path rule fixed-target port 445 target-addr
10.2.0.2
client-SH (config) # in-path rule fixed-target port 21 target-addr
10.2.0.2
client-SH (config) # in-path rule fixed-target port 80 target-addr
10.2.0.2
client-SH (config) # in-path rule pass-through
client-SH (config) # write memory
client-SH (config) # exit
Now add the service group to the HP EFS WAN Accelerator so that the router starts
redirecting packets.
To add the WCCP
service group to the
HP EFS WAN
Accelerator
• At the system prompt, enter the following set of commands:
client-SH > enable
client-SH # configure terminal
client-SH (config) # wccp enable
client-SH (config) # wccp service-group 90 routers 10.1.0.1
client-SH (config) # write memory
client-SH (config) # restart
This set of commands instructs the router to redirect all TCP traffic to the HP EFS
WAN Accelerator.
Configuring WCCP Using the Management
Console
The following section describes the basic steps for configuring the HP EFS WAN
Accelerator using the Management Console.
This section does not describe how you enable your router for WCCP and create a
service group for the HP EFS WAN Accelerator. For detailed information about
configuring your router, see “Configuring the WCCP Router or Multi-Layer Switch”
on page 68.
In this example, the client-side HP EFS WAN Accelerator IP address 10.1.0.2, its
WAN router is 10.1.0.1, and the server-side HP EFS WAN Accelerator, IP address is
10.2.0.2.
Basic Steps
(Client-Side)
Perform the following steps for the client-side HP EFS WAN Accelerator.