HP StorageWorks Enterprise File Services WAN Accelerator 2.1.5 deployment guide (June 2006)

HP STORAGEWORKS ENTERPRISE FILE SERVICES WAN ACCELERATOR 2.1.5 DEPLOYMENT GUIDE 79
7 - WCCP DEPLOYMENTS
interface Vlan63
ip address 172.20.240.18 255.255.255.252
no ip redirects
ip wccp 91 redirect in
no mls ip
no mls ipx
no cdp enable
!
ip classless
ip route 10.11.21.0 0.0.0.255 172.20.240.17
ip route 10.11.22.0 0.0.0.255 172.20.240.17
ip flow-export version 5
no ip http server
!
line con 0
exec-timeout 0 0
line vty 0 4
password 7 06541B2E5C175958
login
!
end
To configure the client-
side HP EFS WAN
Accelerator
• At the system prompt, enter the following set of commands:
client-SH > enable
client-SH # configure terminal
client-SH (config) # interface in-path ip address 10.11.22.46 /16
client-SH (config) # in-path oop enable
client-SH (config) # in-path enable
client-SH (config) # wccp enable
client-SH (config) # wccp service-group 90 routers 10.11.22.17
flags,dst-ip-hash priority 200 weight 3 encap_scheme either
client-SH (config) # write memory
client-SH (config) # restart
To configure the
server-side HP EFS
WAN Accelerator
At the system prompt, enter the following set of commands:
server-SH > enable
server-SH # configure terminal
server-SH (config) # interface in-path ip address 10.11.24.200 /16
server-SH (config) # in-path oop enable
server-SH (config) # in-path enable
server-SH (config) # wccp enable
server-SH (config) # wccp service-group 91 routers 10.11.24.250
flags,dst-ip-hash priority 200 weight 6 encap_scheme either
server-SH (config) # write memory
server-SH (config) # restart
Additional WCCP Features
This section describes the additional features for WCCP.
Security WCCP protocol messages can be authenticated between the router and the HP EFS
WAN Accelerator using a password. The maximum password length is 8 characters.
To set the password
for WCCP
1. On the router, at the system prompt, enter the following command: