HP StorageWorks Enterprise File Services WAN Accelerator 2.1.5 deployment guide (June 2006)

HP STORAGEWORKS ENTERPRISE FILE SERVICES WAN ACCELERATOR 2.1.5 DEPLOYMENT GUIDE 89
8 - PROXY FILE SERVICE
D
EPLOYMENTS
Configuring PFS Using the Management
Console
The following sections provide the basic steps for joining the domain for PFS, and
configuring PFS shares for Broadcast, Local, or Stand-Alone mode using the
Management Console.
To join a domain for
PFS
1. Install and start the HP EFS RCU on the HP EFS RCU server, which by default
listens on port 8777. The RCU service must be started with a domain account that
has write access to the share on the origin server.
2. Configure the HP EFS WAN Accelerator as an in-path device. For detailed
information, see the HP StorageWorks Enterprise File Services WAN Accelerator
Installation and Configuration Guide.
IMPORTANT: HP EFS RCU traffic from the HP EFS WAN Accelerator originates through the
Primary Interface. To ensure proper optimization of HP EFS RCU traffic, make sure traffic from
your Primary interface goes through the same switch as your LAN interface. For detailed
information, see the HP StorageWorks Enterprise File Services WAN Accelerator Installation
and Configuration Guide.
3. Connect to the Management Console. For detailed information, see the HP
Enterprise File Services WAN Accelerator Management Console User Guide.
4. Navigate to the Setup: Proxy File Service (PFS) - Configuration page. You will
need to join a domain the first time you configure PFS.