HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 Command-Line Interface reference manual (AG421-96004, March 2007)

HP STORAGEWORKS EFS WAN ACCELERATOR COMMAND-LINE INTERFACE REFERENCE MANUAL 155
4 - CONFIGURATION-MODE
C
OMMANDS
Example minna (config) # protocol mapi 2k3 enable
minna (config) #
protocol mapi nspi
Description Sets the Name Service Provider Interface (NSPI) port. In certain situations (for
example, clients connecting through a firewall), you might want to force a server to
listen on a single pre-defined port so that access to ports can be controlled or locked
down on the firewall.
The no command option resets the NSPI port to the default value.
In out-of-path deployments, if you want to optimize MAPI Exchange by destination
port. You must define in-path rules that specify the following ports on the client-side
HP EFS WAN Accelerator:
 Port 135. The Microsoft end-point mapper port.
 Port 7830. The HP EFS WAN Accelerator port used for Exchange traffic.
 Port 7840. The HP EFS WAN Accelerator port used for Exchange Directory
NSPI traffic.
If you changed the Microsoft Exchange Information Store Interface port in your
environment, change port 7830 to the static port number you have configured in your
Exchange environment. The CLI commands for MAPI and NSPI port configuration
are:
protocol mapi port <port>
protocol mapi nspi port <port>
For further information, see Microsoft Exchange Information Store Interface at http:/
/support.microsoft.com/default.aspx?scid=kb;en-us;270836.
Syntax [no] protocol mapi nspi <port>
Parameters
Example
minna (config) # protocol mapi nspi port 2125
minna (config) #
protocol mapi nspi enable
Description Enables NSPI MAPI. NSPI MAPI is enabled by default.
The no command option disables NSPI MAPI optimization for testing purposes.
Syntax [no] protocol mapi nspi enable
Example
minna (config) # protocol mapi nspi enable
minna (config) #
<port> Specifies the incoming NSPI port number. The default value is 7840.