HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 Command-Line Interface reference manual (AG421-96004, March 2007)

186 4 - CONFIGURATION-MODE COMMANDS
Parameters
<type> Specifies the following types of alarms:
• admission_conn. Cannot be disabled. Whether the system connection
limit has been reached. Additional connections are passed through
unoptimized. The alarm clears when the HP EFS WAN Accelerator
moves out of this condition.
• admission_mem. Cannot be disabled. Whether the system connection
memory limit has been reached. Additional connections are passed
through unoptimized. The alarm clears when the HP EFS WAN
Accelerator moves out of this condition.
• bypass. Cannot be disabled. Whether the system is in bypass mode. If
the HP EFS WAN Accelerator is in bypass mode, restart the HP EFS
WAN Accelerator service.
• cpu_util_indiv. Whether the system has reached the CPU threshold for
any of the CPUs in the HP EFS WAN Accelerator If the system has
reached the CPU threshold, check your settings.
If your alarm thresholds are correct, reboot the HP EFS WAN Accelerator.
NOTE: If more than 100 MB of data is moved through an HP EFS WAN
Accelerator, Model 1010 while performing PFS synchronization, the CPU
utilization might become high and result in a CPU alarm. This CPU alarm
should not be cause for concern.
• critical_temp. Whether the CPU temperature has exceeded the critical
threshold. The default value for the rising threshold temperature is 70º C;
the default reset threshold temperature is 67º C.
• duplex. Whether a duplex error has been encountered.
• fs_mnt. Whether the system has detected a file system error in the
software.
• halt_error. Cannot be disabled.Whether the system has detected a
software error in the HP EFS WAN Accelerator service, the HP EFS
WAN Accelerator service continues to function, but an error message
appears in the logs that you should investigate.
• linkstate. Whether the system has detected a link that is down. You are
notified via SNMP traps, email, and alarm status.By default this alarm is
not enabled. The no stats alarm linkstate enable command disables the
link state alarm.
• mismatch_peer. Whether there is a mismatch between software
versions in your network. If a software mismatch is detected, resolve the
mismatch by upgrading or reverting to a previous version of the
software.
• nfs_v2_v4.Whether the system has triggered a v2 or v4 NFS alarm.
• store_corruption. Cannot be disabled. Whether the data store is corrupt.
To clear the data store of data, restart the HP EFS WAN Accelerator
service and click Clear Data Store on Next Restart.
• sw_version. Whether there is a mismatch between software versions in
your network. If a software mismatch is detected, resolve the mismatch
by upgrading or reverting to a previous version of the software.
• warning_temp.Whether the CPU temperature has exceeded the warning
threshold. The default value for the rising threshold temperature is 70º C;
the default reset threshold temperature is 67º C.