HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 Command-Line Interface reference manual (AG421-96004, March 2007)

HP STORAGEWORKS EFS WAN ACCELERATOR COMMAND-LINE INTERFACE REFERENCE MANUAL 187
4 - CONFIGURATION-MODE
C
OMMANDS
Example minna (config) # stats alarm bypass enable
minna (config) #
stats chd
Description Sets computed historical data points.
Syntax stats chd <CHD ID> clear
Parameters
<type> • paging.Whether the system has reached the memory paging threshold. If
100 pages are swapped approximately every two hours the HP EFS
WAN Accelerator is functioning properly. If thousands of pages are
swapped every few minutes, then reboot the HP EFS WAN Accelerator.
• pfs_config.Whether there has been a PFS connection error. If a
connection error is detected, restart the HP EFS WAN Accelerator
service and PFS.
• pfs_disk_full. Whether you Proxy File Service (PFS) partition is full.
• pfs_operation. Whether a synchronization operation has failed. If an
operation failure is detected, attempt the operation again.
• power_supply. Whether an error has been detected in the power supply
unit; restart the HP EFS WAN Accelerator service. If that does not clear
the alarm, shut down the system and restart.
• rcu_error. Cannot be disabled. Whether an RCU error has occurred.
• service_error. Cannot be disabled. Whether a service error has
occurred.
<options> Specifies the following alarm options:
• clear. Clears alarm settings.
• enable. Enables alarm.
• rate-limit {count [long | medium | short] | [reset] | [window [long |
medium | short]}. Sets alarm event rate-limit values.
• rising. Sets the rising threshold.
• rising clear_threshold <amount>. Sets the threshold to clear rising
alarm. The default value for CPU temperature is 47º C.
• rising error_threshold <amount>. Sets threshold to trigger rising
alarm. The default value for the CPU temperature is 50º C.
• falling. Sets the falling threshold.
• falling clear_threshold <amount>. Sets the threshold to clear falling
alarm. The default value for the CPU temperature is 0º C.
• falling error_threshold <amount>. Sets the threshold to trigger falling
alarm. The default value for the CPU temperature is 0º C.
These options are available only for applicable alarms.
<CHD ID> Specifies the specific data point: <CHD ID>, cpu_util, cpu_util_indiv,
cpu_util_day, duplex_aux, duplex_lan, duplex_pri, duplex_wan,
memory_day, paging, paging_day, rbt, rbt_day, rbt_month, rbt_week,
rbtkernel, rbtkernel_day, rbtkernel_month, rbtkernel_week.
clear Clears all data.