HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 Command-Line Interface reference manual (AG421-96004, March 2007)

HP STORAGEWORKS EFS WAN ACCELERATOR COMMAND-LINE INTERFACE REFERENCE MANUAL 19
1 - USING THE COMMAND-LINE
I
NTERFACE
CHAPTER 1 Using the Command-Line
Interface
In This Chapter This chapter describes how to access and use the HP EFS WAN Accelerator
command-line interface (CLI). This chapter includes the following sections:
 “Connecting to the CLI,” next
 “Overview of the CLI” on page 20
 “Entering Commands” on page 21
 “Accessing Online Help” on page 21
 “Error Messages” on page 21
 “Command Negation” on page 21
 “Saving Configuration Changes” on page 22
Connecting to the CLI
This section assumes you have already performed the initial setup of the HP EFS WAN
Accelerator using the configuration wizard. For detailed information, see the HP
StorageWorks Enterprise File Services WAN Accelerator installation and
configuration guide.
To connect the CLI 1. You can connect to the CLI using one of the following options:
 An ASCII terminal or emulator that can connect to the serial console. It must
have the following settings: 9600 baud, 8 bits, no parity, 1 stop bit, and no flow
control.
 A computer with a Secure Shell (ssh) client that is connected to the HP EFS
WAN Accelerator Primary port (in rare cases, you might connect through the
Auxiliary port).
2. At the system prompt, enter the following command: