HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 Command-Line Interface reference manual (AG421-96004, March 2007)

HP STORAGEWORKS EFS WAN ACCELERATOR COMMAND-LINE INTERFACE REFERENCE MANUAL 27
3 - ENABLE-MODE COMMANDS
CHAPTER 3 Enable-Mode Commands
In This Chapter This chapter is a reference for enable-mode commands. Enable-mode commands are
commands that display process information.
To enter enable mode 1. Connect to the CLI. For detailed information, see “Connecting to the CLI” on
page 19.
2. To enter enable mode, at the system prompt enter:
host > enable
host #
To exit enable mode, enter exit. For information about the exit command, see “exit”
on page 23.
This chapter describes the following enable-mode commands:
 “configure terminal,” next
 “debug generate dump” on page 30
 “disable” on page 30
 “file debug-dump” on page 31
 “file stats” on page 31
 “reload” on page 31
 “restart” on page 32
 “show aaa” on page 32
 “show arp” on page 32
 “show banner” on page 33
 “show bootvar” on page 33
 “show cli” on page 33
 “show clock” on page 34
 “show cmc” on page 34
 “show configuration” on page 34
 “show configuration files” on page 35