HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 Command-Line Interface reference manual (AG421-96004, March 2007)

60 3 - ENABLE-MODE COMMANDS
Logical Drives : 01 DRAM : 64MB
Rebuild Rate : 30%
Flush Interval : 4 secs
Number Of Chnls : 1 Bios Status : Enabled
Alarm State : Enabled Auto Rebuild : Enabled
FW : SPAN-8, 40-LD BIOS Config AutoSelection : USER
BIOS Echos Mesg : ON BIOS Stops On Error : ON
Initiator Id : 16(Clustered Firmware)
Board SN: {STX}33686018
**********************************************************************
show raid physical
Description Displays RAID physical details.
Syntax show raid physical
Parameters None
Example
minna # show raid physical
Adapter 0, Channel 0, Target ID 0
----------------------------------------
Type: DISK Vendor : WDC
Product: WD2500SD-01KCB0 Revision : 08.0
Synchronous : No Wide-32 : No Wide-16: No
LinkCmdSupport: No TagQ support: No RelAddr: No
Removable : No SoftReset : No AENC : No
Adapter 0, Channel 0, Target ID 1
----------------------------------------
Type: DISK Vendor : WDC
Product: WD2500SD-01KCB0 Revision : 08.0
Synchronous : No Wide-32 : No Wide-16: No
LinkCmdSupport: No TagQ support: No RelAddr: No
Removable : No SoftReset : No AENC : No
(this is a partial example)
show running-config
Description Displays the running configuration. The show running-config full command
displays all settings, including those set to the default value.
Syntax show running-config [full]
Parameters
Example
minna # show running-config
(displays running configuration)
full Displays all settings, including those set to the default value.