HP StorageWorks Enterprise File Services WAN Accelerator 3.0.4 Command-Line Interface reference manual (AG421-96004, March 2007)

HP STORAGEWORKS EFS WAN ACCELERATOR COMMAND-LINE INTERFACE REFERENCE MANUAL 73
4 - CONFIGURATION-MODE
C
OMMANDS
CHAPTER 4 Configuration-Mode Commands
In This Chapter This chapter is a reference for configuration-mode commands. Configuration-mode
commands set configuration properties for the HP EFS WAN Accelerator.
To execute configuration-mode commands, you must first enter enable mode.
To enter configuration
mode
1. Connect to the CLI. For detailed information, see “Connecting to the CLI” on
page 19.
2. To enter enable mode, at the system prompt enter:
host> enable
3. To enter configuration mode, at the system prompt enter:
host # configure terminal
host (config) #
You are in configuration mode.
To exit configuration mode, enter exit. For information about the exit command, see
“exit” on page 23.
This chapter describes the following configuration mode commands:
 “aaa authentication login default,” next
 “aaa authorization map default-user” on page 81
 “aaa authorization map order” on page 81
 “arp” on page 82
 “banner” on page 82
 “boot system” on page 83
 “clear arp-cache” on page 83
 “cli clear-history” on page 83
 “cli default auto-logout” on page 83
 “cli default paging enable” on page 84
 “cli session” on page 84