HP StorageWorks File System Extender Software V3.4 CLI reference (T3648-96013, October 2006)

2.9 NAME 70

– if – –remove, – –mark–unreliable, – –mark–unusable or – –mark–

good option is speciﬁed, skip FSE administrator’s conﬁrmation of FSE

medium removal, marking the medium unreliable, marking it unusable

or marking it "good"; treat it as if FSE administrator would have an-

swered the conﬁrmation question with "Yes".

– if the – –duplicate option is speciﬁed, allow duplication also to FSE

media that either contain valid data or header such as a tar archive,

ECMA or ANSI label, have already been initialized, or belong to FSE

media pool that is already assigned to an FSE partition.

• –i, – –init

Initialize the speciﬁed or all FSE medium volumes on the FSE medium

with barcode Barcode. Initializing an FSE medium volume means (over–

)writing its volume header, thus preparing this volume for usage in the FSE

implementation.

Note:

FSE medium volume must be associated (via its FSE medium and FSE

media pool) to an FSE partition before it can be initialized. If the

medium volume is not empty, its initialization is allowed only if ad-

ditional option – –force is speciﬁed. Backup media should not be ini-

tialized, but formatted only.

• – –no–monitor

Disable monitoring of the formatting, initialization, maintenance, or reorga-

nization job which is to be performed on the FSE medium. Monitoring is en-

abled by default. For details on monitoring, see section JOB PROGRESS

MONITORING.

• VolumeNumber...

A non–negative integer value or a sequence of such values which repre-

sent(s) the position(s) of FSE medium volume(s) on the medium layout.

• – –mark–unreliable

Disallow writing to the FSE medium with barcode Barcode. From that

moment on, the data on the medium can only be read. This is done by

setting the status of this medium in the Resource Management Database

HP StorageWorks File System Extender Software CLI reference