FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-62
Enterprise Operating System Command Line Interface User Manual
config
Parameters This command has no parameters.
Command Example
config security ssh show
Output The output of the config.security.ssh.show command displays the
following data:
Output Example
SSH: enabled
Telnet: disabled
config.security.switchAcl
The access control list (ACL) feature allows a user with appropriate
rights to configure a set of IP addresses that are allowed to make an
IP management connection to the product.
config.security.switchAcl.addRange
Syntax addRange startIPAddress endIPAddress
Purpose This command adds a new range of IP addresses to the access control
list.
Parameters This command has the following parameters:
The maximum number of entries in this command is 32.
SSH Indicates if the SSH interface to CLI is
enabled or disabled.
Telnet Indicates if the Telnet interface to CLI is
enabled or disabled.
startIPAddress The starting IP Address of the desired range.
The address must be entered in dotted decimal
form (such as, 10.0.0.0).
endIPAddress The ending IP Address of the desired range.
The address must be entered in dotted decimal
form (such as, 10.0.0.0).