FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-64
Enterprise Operating System Command Line Interface User Manual
config
Command Example Root> config security switchAcl setState 1
config.security.switchAcl.show
Syntax show
Purpose This command displays the contents of the access control list.
Parameters This command has no parameters.
Command Example
Root> config security switchACL show
Output This command displays the following access control list information:
Output Example The output from the config.security.switchAcl.show command
displays as follows.
ACL State: Disabled
Starting IP Address Ending IP Address
------------------- -----------------
110.80.1.1 110.80.255.255
110.81.1.10 110.81.1.255
200.11.15.1 200.11.255.128
config.security.switchBinding
Switch Binding CLI commands allow you to enable the product to
communicate only with nodes, switches, and directors that are listed
on the Switch Binding Membership List (SBML). Switch Binding
restricts connections to only the devices listed on the SBML and
allows no other devices to communicate with the switch. When an
unauthorized WWN attempts to log in, it is denied a connection and
an event is posted to the Event Log. This provides security in
environments that include a large number of nodes, switches, and
directors by ensuring that only the specified set of WWNs are able to
attach to the managed product.
Starting IP
Address
The starting IP Address of the range in the
access control list.
Ending IP
Address
The ending IP Address of the range in the
access control list.