FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-72
Enterprise Operating System Command Line Interface User Manual
config
Output Example The output from the config.snmp.show command displays as
follows.
SNMP Agent State: Enabled
FA MIB Version Number: 3.0
Authentication Traps: Enabled
Index Community Name WriteAuth Trap Recipient UDP Port
----- ----------------------------- --------- --------------- ------
1 CommunityName1 Enabled 123.123.123.123 162
2 CommunityName2 Enabled 10.25.25.10 144
3 CommunityName3 Disabled 132.44.85.224 162
4 public Enabled 162
5
6
config.switch
All commands under this branch operate on a particular switch
attribute. Switch attributes are those attributes that are specific to the
Fibre Channel switch nature of the product.
Some of the config.switch commands require that the switch be set
offline. (Use the maint.system.setOnlineState to set the switch
offline.) If these commands are entered while the switch is online, an
error message results.
config.switch.domainRSCN
Syntax domainRSCN domainRSCNState
Purpose This command sets the domain RSCN state for the switch. The switch
can be either offline or online when this command is executed. When
this parameter is enabled, domain register for state change
notifications (domain RSCNs) are sent between end devices in a
Community
Name
The name of the community.
WriteAuth The write authorization state.
Trap Recipient The address of the trap recipient shown in
4-byte dotted-decimal format.
UDP Port The user datagram protocol (UDP) port number
to which the director will send traps for each
recipient.