FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-73
config
fabric to provide additional connection information to host bus
adapters (HBA) and storage devices. As an example, this information
might be that a logical path has been broken because of a physical
event, such as a fiber optic cable being disconnected from a port.
Parameters This command has one parameter.
Command Example
Root> config switch domainRSCN 1
config.switch.edTOV
Syntax edTOV timeoutValue
Purpose This command sets the E_D_TOV for the switch.
NOTE: The switch must be set offline before this command is entered.
Special care should be used when scripting this command due to its
relationship with R_A_TOV.
Parameters This command has one parameter.
Command Example
Root> config switch edTOV 4
config.switch.insistDomainId
Syntax insistDomainId insistentDomainIdState
Purpose This command sets the insistent domain ID state for the switch.
domainRSCNState Specifies whether the domain RSCN state is
enabled. Valid values are enable and disable.
Boolean 1 and 0 may be substituted as values.
timeoutValue Specifies the new E_D_TOV value. The units for
this value are tenths of a second. This parameter
must be an integer in the range 2–600
(0.2 second to 60 seconds), and it must be
smaller than the R_A_TOV.