FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-74
Enterprise Operating System Command Line Interface User Manual
config
Parameters This command has one parameter.
Command Example
Root> config switch insistDomainId 1
NOTE: The Insistent Domain ID must be enabled, if the Enterprise Fabric
Mode (an optional SANtegrity feature) or Preferred Path is enabled.
config.switch.interopMode
Syntax interopMode interopMode
Purpose This command sets the interoperability mode for the switch. The
switch must be offline to complete this command.
NOTE: The switch must be set offline before this command is entered.
Parameters This command has one parameter.
Command Example
Root> config switch interopMode open
config.switch.ltdFabRSCN
Syntax ltdFabRSCN ltdFabRSCNState
insistentDomainIdState Specifies whether the insistent domain ID
state is enabled. Valid values are enable and
disable. Boolean 1 and 0 may be substituted
as values.
interopMode Specifies the interoperability mode. Valid
values are mcdata and open:
mcdata — McDATA Fabric 1.0. Select this mode
if the fabric contains only McDATA switches
and directors that are also operating in
McDATA Fabric 1.0 mode.
open — Open Fabric 1.0. Select this mode if the
fabric contains McDATA switches and directors
and other open-fabric compliant switches.
Select this mode for managing heterogeneous
fabrics.