FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-75
config
Purpose This command sets the status of limited fabric RSCNs. When enabled,
fabric register for state change notifications (RSCNs) are suppressed
during an IPL.
Parameters This command has one parameter.
Command Example
Root> config switch ltdFabRSCN 1
config.switch.prefDomainId
Syntax prefDomainId domainId
Purpose This command sets the preferred domain ID for the switch. The
switch must be offline to complete this command.
NOTE: The switch must be set offline before this command is entered.
Parameters This command has one parameter.
Command Example
Root> config switch prefDomainId 1
config.switch.priority
Syntax priority Priority
Purpose This command sets the switch priority.
NOTE: The switch must be set offline before this command is entered.
ltdFabRSCNState Specifies whether the limited fabric RSCN state
is enabled. Valid values are enable and disable.
Boolean 1 and 0 may be substituted as values.
domainId Specifies the new preferred domain ID value.
This parameter must be an integer in the range
1–31.