FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-76
Enterprise Operating System Command Line Interface User Manual
config
Parameters This command has one parameter.
Command Example
Root> config switch priority principal
config.switch.raTOV
Syntax raTOV timeoutValue
Purpose This command sets the R_A_TOV for the switch.
NOTE: The switch must be set offline before this command is entered.
Special care should be used when scripting this command due to its
relationship with E_D_TOV.
Priority Specifies the switch priority. Valid values are:
principal, default, or neverprincipal.
principal — sets the numerical switch priority
to 1. The switch with a priority of 1 becomes the
principal switch; however, if two or more
switches have a priority of 1, the switch with
the lowest WWN becomes the principal switch.
default — sets the numerical switch priority
to 254. If no switch is set to principal, the switch
with a priority 254 becomes the principal
switch; however, if two or more switches have a
priority of 254, the switch with the lowest
WWN becomes the principal switch.
neverprincipal — sets the numerical switch
priority to 255. This switch is not able to become
the principal switch.
At least one switch in a multiswitch fabric must
have a switch priority value of principal or
default.
The number codes 2–253 are not now in use.