FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-79
config
Purpose This command shows the switch configuration.
NOTE: The switch can be either offline or online when this command is
executed.
Parameters This command has no parameters.
Command Example
Root> config switch show
Output The switch configuration data is displayed as a table that includes the
following properties.
BB Credit The maximum number of outstanding frames
that can be transmitted without causing a buffer
overrun condition at the receiver. (This is not
valid for the Sphereon 4300 and Sphereon 4500
switches.)
R_A_TOV Resource Allocation Time Out Value.
This value is set in tenths of a second.
E_D_TOV Error Detect Time Out Value.
This value is set in tenths of a second.
Preferred
Domain Id
The preferred domain ID of the switch.
Switch Priority The switch priority. Values are Principal,
Default, or Never Principal.
Speed The switch speed. (This is not valid for the
Sphereon 4300 and Sphereon 4500 switches.)
Rerouting Delay The rerouting delay that ensures that frames are
delivered in order through the fabric to their
destination. Values are Enabled or Disabled.
Interop Mode Interoperability mode for the switch.
Insistent Domain
Id
When enabled, ensures that the embedded
firmware cannot change a switch's preferred
domain ID.
Domain RSCN When enabled, allows domain RSCNs to be sent
to registered members of the fabric.