FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-86
Enterprise Operating System Command Line Interface User Manual
config
NOTE: If the interoperability mode for the switch or director is set to Open
Fabric 1.0 mode when the zone is activated, any zone members specified by
port number are ignored.
config.zoning.addPortMem
Syntax addPortMem “zoneName” domainId portNumber
Purpose This command adds the domain ID and port number of a zone
member to the specified zone in the work area.
NOTE: Port numbers cannot be used for zone members if the interoperability
mode for the switch or director is set to Open Fabric 1.0 mode.
NOTE: A product can have at most 1024 zone members in its zones.
NOTE: The ED-5000 supports a maximum of 512 zones.
Parameters This command has the following parameters.
Command Example
Root> config zoning addPortMem TheUltimateZone 10 6
zoneName Specifies the name of the zone.
domainId Specifies the domain ID of the member to be
added to the zone. Valid values are in the range
1–31.
portNumber Specifies the port number of the member to be
added to the zone. Valid port number values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0–31 for the ED-5000
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140