FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-89
config
config.zoning.deactivateZoneSet
Syntax deactivateZoneSet
Purpose This command places all attached devices in the default zone and
takes effect immediately for the entire fabric. This command clears
both the active zone set and the working area.
This command takes
effect immediately in the fabric.
NOTE: The default zone must be activated independently of this command.
Parameters This command has no parameters.
Command Example
Root> config zoning deactiveZoneSet
config.zoning.deletePortMem
Syntax deletePortMem zoneName domainId portNumber
Purpose This command deletes a domain ID and port number for a zone
member in the specified zone in the work area.
Parameters This command has three parameters.
Command Example
Root> config zoning deletePortMem TheUltimateZone 10 5
zoneName Specifies the name of the zone that contains the
member to be deleted.
domainId Specifies the domain ID of the member that to
be deleted from the zone. Valid domain IDs are
in the range 1–31.
portNumber Specifies the port number of the member to be
deleted from the zone. Valid port numbers
values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0–31 for the ED-5000
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140