FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-90
Enterprise Operating System Command Line Interface User Manual
config
config.zoning.deleteWwnMem
Syntax deleteWwnMem zoneName wwn
Purpose This command removes a WWN member from a zone that is in the
work area.
Parameters This command has two parameters.
Command Example
Root> config zoning deleteWwnMem TheNotSoUltimateZone
10:00:00:00:C9:22:9B:AB
config.zoning.deleteZone
Syntax deleteZone zoneName
Purpose This command deletes a zone from the zone set in the work area.
NOTE: Changes are not activated on the switch until the
config.zoning.activeZoneSet command is issued.
Parameters This command has one parameter.
Command Example
Root> config zoning deleteZone TheLeastUltimateZone
zoneName Specifies the name of the zone that contains the
member to be deleted.
wwn Specifies the WWN of the member to be deleted
from the zone. The value of the WWN must be
in colon-delimited hexadecimal notation (for
example, AA:00:AA:00:AA:00:AA:00).
zoneName Specifies the name of the zone to be deleted.