FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-91
config
config.zoning.renameZone
Syntax renameZone oldZoneName newZoneName
Purpose This command renames a zone in the work area.
Parameters This command has two parameters.
Command Example
Root> config zoning renameZone TheOldUltimateZone
TheUltimateZone
config.zoning.renameZoneSet
Syntax renameZoneSet zoneSetName
Purpose This command changes the name of the zone set in the work area.
NOTE: Changes are not activated on the switch until the
config.zoning.activateZoneSet command is issued.
Parameters This command has one parameter.
oldZoneName Specifies the current zone name of the zone to
be renamed.
newZoneName Specifies the new zone name. The
newZoneName must contain 1–64 characters.
Valid characters are:
ABCDEFGHIJKLMNOPQRSTUVWXYZabcdef
ghijklmnopqrstuvwxyz0123456789$-^_
Spaces are not permitted, and the first character
must be alphabetical.
zoneSetName Specifies the new name for the zone set. The
zoneSetName must contain 1–64 characters.
Valid characters are:
ABCDEFGHIJKLMNOPQRSTUVWXYZabcdef
ghijklmnopqrstuvwxyz0123456789$-^_
Spaces are not permitted, and the first character
must be alphabetical.