FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-92
Enterprise Operating System Command Line Interface User Manual
config
Command Example Root> config zoning renameZoneSet TheUltimateZoneSet
config.zoning.replaceZoneSet
Syntax replaceZoneSet
Purpose This command replaces the work area with the active zone set that is
currently loaded on the fabric.
Parameters This command has no parameters.
Command Example
Root> config zoning replaceZoneSet
config.zoning.setDefZoneState
Syntax setDefZoneState defaultZoneState
Purpose This command enables or disables the default zone and takes effect
immediately fabric wide.
NOTE: This command takes effect immediately in the fabric.
Parameters This command has one parameter.
Command Examples
Root> config zoning setDefZoneState false
Root> config zoning setDefZoneState 0
config.zoning.showActive
Syntax showActive
Purpose This command shows the zoning configuration saved on the fabric.
Parameters This command has no parameters.
Command Example
Root> config zoning showActive
defaultZoneState Specifies whether the default zone is enabled.
Valid values are true and false. Boolean 1 and 0
may be substituted as values.