FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-97
maint
maint.system.clearSysError
Syntax clearSysError
Purpose This command clears the system error light.
Parameters This command has no parameters.
Command Example
Root> maint system clearSysError
maint.system.ipl
Syntax ipl
Purpose This command IPLs the switch.
ATTENTION! Connection to the CLI is lost when this command runs.
Parameters This command has no parameters.
Command Example
Root> maint system ipl
maint.system.resetConfig
Syntax resetConfig
Purpose This command resets all NV-RAM configuration parameters to their
default values, including feature keys and IP addresses.
NOTE: This command IPLs the switch. Connection from the CLI to the
switch is lost when this command runs.
ATTENTION! This command resets all configuration data and non-volatile
settings, including network information, to their default values (factory
settings). Management access may be lost until the network information is
restored.
The default values are set in the firmware of the director or switch.
For information about the default values, refer to the service manual
for your director or switch.
Parameters This command has no parameters.