FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-105
perf
Output Example The output from the perf.link command displays as follows.
Port 2
Statistic Count
----------- ----------
OLS In 753452
OLS Out 351269
Reset In 2953184
Reset Out 1842953
Link Flrs 2953184
Sync Losses 1842953
Sig Losses 35246
Time at 0 Tx Credit 0
perf.openTrunking.backPressure
Syntax backPressure backPressureState
Purpose This command configures the Back Pressure state of the
OpenTrunking configuration.
Reset Out The number of link resets initiated by this
director or switch.
LIPS In The number of Loop Initialization Primitives
(LIPS) detected on this switch loop port.
LIPS Out The number of LIPS generated on this switch
loop port.
Link Flrs The number of times the port has detected a
link error resulting from an invalid link state
transition or timeout.
Sync Losses The number of times the port has detected a
loss of synchronization timeout while not in an
offline or LF2 state.
Sig Losses The number of times the port has detected a
loss of signal while not in an offline or LF2 state.
Time at 0 Tx
Credit
The number of 100 millisecond intervals where
the switch port has zero Tx BB credit.