FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-106
Enterprise Operating System Command Line Interface User Manual
perf
Parameters This command has one parameter.
Command Example
Root> perf openTrunking backPressure 1
perf.openTrunking.congestionThresh
Syntax congestionThresh portNumber congestionThreshold
Purpose This command configures the congestion threshold for an individual
port or for all ports.
Parameters This command has the following parameters.
Command Example
Root> perf openTrunking congestionThresh 8 20
perf.openTrunking.lowBBCreditThresh
Syntax lowBBCreditThresh lowBBcreditThreshold
Purpose This command configures the low BB_credit threshold of the
OpenTrunking configuration. The low BB_credit threshold is defined
backPressureState This parameter can be set to enable or disable
OpenTrunking back pressure. Boolean 1 and 0
values may also be substituted. If the state is
configured to be enabled, a back pressure
entry is made to the Event Log and an SNMP
trap is generated if SNMP is configured.
portNumber Specifies the port number. Valid values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
all applies the congestionThreshold value to
every port on the product.
congestionThreshold Specifies the congestion threshold in terms
of a percentage. Valid values are integers in
the range 1 to 99 or default. Specifying the
value default sets the specified port to the
default threshold level of 10.