FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-112
Enterprise Operating System Command Line Interface User Manual
perf
Parameters This command has the following parameters.
Command Example
Root> perf preferredPath setPath 17 5 11
perf.preferredPath.setState
Syntax setState enabledState
Purpose This command enables or disables the Preferred Path feature.
NOTE: Insistent domain IDs must be used in order to enable the preferred
path state.
destDomainId Specifies the destination domain ID. Valid
domain IDs are in the range 1–31.
sourcePort Specifies the number of the source port. Valid
port numbers values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0–31 for the ED-5000
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
exitPort Specifies the number of the desired exit port.
Valid port numbers values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0–31 for the ED-5000
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140