FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-113
perf
Parameters This command has one parameter.
Command Example
Root> perf preferredPath setState enable
perf.preferredPath.showPath
Syntax showPath destDomainID sourcePort
Purpose This command displays the requested Preferred Path configuration.
The output shows the configured preferred exit port. Using all for
either the destination domain ID or the specified source Port
parameter results in output that shows all configured and actual exit
ports for the other parameter. If the destination domain is set to all,
then all paths from the specified source port are displayed. If the
source port is set to all, the output shows all source port paths to the
specified domain. You cannot specify all for both of those parameters.
enabledState Sets the state of the preferred path
feature. When disabled, the preferred
path settings are ignored for all path
selection decisions. Accepted values for
this command are enable and disable.
Boolean 1 and 0 may be substituted as
values.