FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-114
Enterprise Operating System Command Line Interface User Manual
perf
Parameters This command has the following parameters.
Output The output from perf.preferredPath.showPath includes the following
parameters.
destDomainId Specifies the destination domain ID. Valid
domain IDs are in the range 1–31 or all, which
shows all paths to and from the source port
specified in the sourcePort parameter.
sourcePort Specifies the number of the source port. Valid
port numbers values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0–31 for the ED-5000
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
Or, you can specify all to show all paths to the
destination domain ID specified for the
destDomainId parameter.
Destination
Domain
The destination domain ID for which a
preferred path has been configured. This is
displayed only if the destination domain
parameter is set to all.
Source Port This is the source port for which a preferred
path to the specified destination domain ID is
specified. This is displayed only if the source
port parameter is set to all.
Preferred Exit
Port
The configured Preferred Path exit port. This
value can be any port number, or blank to
indicate that no Preferred Path has been
configured.