FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-118
Enterprise Operating System Command Line Interface User Manual
perf
5. Configure the threshold alert using other perf.thresholdalert
commands. For example, you may want to set the duration and
interval times for the alert, as described in
perf.thresholdAlerts.throughput.setParams on page 2-134. Use the
following commands to view alert settings and configure an alert:
• perf.thresholdAlerts.throughput.removePort on page 2-131
• perf.thresholdAlerts.throughput.setParams on page 2-134
• perf.thresholdAlerts.throughput.show on page 2-135
• perf.thresholdAlerts.throughput.showUtilTypeTable on page 2-135
6. Once the alert is fully configured, it can be activated using the
perf.thresholdAlerts.setState command, described on 2-127. An alert
cannot be modified unless it is in the disabled state.
Alert Types and Counters
Table 2-2 provides a list of throughput threshold alerts.
Table 2-3 provides a list of threshold alert counters and counter sets.
Table 2-2 Throughput Threshold Alerts
Utilization Code Threshold Alert Type
Tx Util TTA - Transmit Utilization
Rx Util TTA - Receive Utilization
Tx/Rx Util TTA - Transmit or Receive
Utilization
Table 2-3 Alert Counters
Number Threshold Alert Counter or Counter Set
1Link Resets Sent
2 Link Resets Received
3OLS Sent
4OLS Received
5 Link Failures