FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-123
perf
NOTE: An alert cannot be modified unless it is in the disabled state. Verify
that the alert is disabled before executing this command.
Parameters This command has the following parameters.
Command Example
Root> perf thresholdAlerts counter removePort checklinks 12
perf.thresholdAlerts.counter.setCounter
Syntax setCounter name counterNumber
Purpose This command sets the counter statistic that will be used to trigger
the counter threshold alert. Use this command to associate a counter
with the threshold alert name created using the
perf.thresholdAlerts.counter.addAlert command.
NOTE: An alert cannot be modified unless it is in the disabled state. Verify
that the alert is disabled before executing this command.
name The name of a counter threshold alert as
defined by the command
perf.thresholdAlerts.counter.addAlert, described
on 2-120.
portNumber Specifies the port number. Valid values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
all removes every port on the product from the
counter threshold alert.