FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-129
perf
Output Example
Name Type State
------------------ --------- ---------
Throughput Threshold #1 Rx Util Enable
Threshold for CRC CRC Errors Disabled
Safety #2 Logic Lnk Err Set Enabled
Safety #1 Cls2 BusiedFrms Disabled
perf.thresholdAlerts.throughput.addAlert
Syntax addAlert name
Purpose This command configures a new throughput threshold alert and
assigns it a name. The new alert is assigned default settings that can
then be changed using the other throughput threshold alert
commands.
The default settings for a new counter threshold alert are as follows:
Address ID Errors CTA - Address ID Errors
Cls2 BusiedFrms CTA - Class 2 Busied Frames
Cls2
RejectedFrms
CTA - Class 2 Rejected Frames
Cls3 DiscardFrms CTA - Class 3 Discarded
Frames
Phys Lnk Err Set CTA - Physical Link Errors
Summed Set
Lnk Seq Cnt Set CTA - Link Sequence Counts
Summed Set
Logic Lnk Err Set CTA - Logical Link Errors
Summed Set
LIPs Detected CTA - Loop Initialization
Primitive Detected
LIPs Generated CTA - Loop Initialization
Primitive Generated
State The enabled state of the CTA. Either enabled or
disabled.