FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-131
perf
Parameters This command has the following parameters.
Specifying a port type removes the alert from all ports and applies
the alert to all ports of the specified type. Valid values are:
• eport
• fport
• flport (Sphereon 4300 and Sphereon 4500 only)
NOTE: This parameter cannot specify both individual port numbers and a
port type.
Command Example Root> perf thresholdAlerts throughput addPort eportRx eport
perf.thresholdAlerts.throughput.removePort
Syntax removePort name portNumber
Purpose This command removes a port from the specified throughput
threshold alert.
name The name of a throughput threshold alert as
defined by the command
perf.thresholdAlerts.throughput.addAlert,
described on 2-129.
portNumber Specifies the port number or port type. Valid
values are either a single port number, all
ports, or port type.
The following port numbers are valid:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
all applies the throughput threshold alert to
every port on the product.