FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
CLI Commands
2-135
perf
perf.thresholdAlerts.throughput.show
Syntax show name
Purpose This command displays the settings for an individual throughput
threshold alert.
Parameters This command has the following parameter.
NOTE: The output of this command truncates threshold alert names that are
longer than 51 characters. If you specify lengthy names, you can display the
complete name by entering the comma-delimited mode using the
commaDelim command. For more information, see Using the commaDelim
Command on page 1-17.
Command Example Root> perf thresholdAlerts throughput show eportRx
Output Example The output from the perf.thresholdAlerts.throughput.show
command displays as follows.
Name: 90% Receive Throughput Threshold
Ports: 5,8,12,20-24
Utilization Type: Rx
Utilization Percentage: 90%
Duration: 15
Interval: 30
Alert State: Disabled
perf.thresholdAlerts.throughput.showUtilTypeTable
Syntax showUtilTypeTable
Purpose This command displays a table of the utilization types that can be
used for a throughput threshold alert. This table is used for reference
only.
name The name of a throughput threshold alert
as defined by the command
perf.thresholdAlerts.throughput.addAlert,
described on 2-129.
You can specify all instead of a name, which
means that all threshold alerts are
displayed.