FW 07.00.00/HAFM SW 08.06.00 McDATA Enterprise Operating System Command Line Interface User Manual (620-000134-720, April 2005)

2
2-138
Enterprise Operating System Command Line Interface User Manual
show
show
The show branch of the CLI command tree contains commands that
display, but do not change, stored data values. The displayed output
that results from these commands is not necessarily identical with the
output from the show commands that are within the other CLI
command tree branches, for example, config.port.show.
The commands in the show branch can by used by either the
administrator or the operator.
show.all
Syntax all
Purpose This command displays all configuration and status information
available. The command results in a sequential display of the output
of other CLI show commands. This set of show commands returns
the full configuration and status of the switch and fabric.
Parameters This command has no parameters.
Command Example
Root> show all
Output The output of this command is a sequential display of the output of
other CLI show commands. The commands are displayed in the
following order:
• show.ip.ethernet
•show.system
•show.switch
•show.port.config
•show.frus
•config.snmp.show
• show.zoning
•show.port.state
• show.port.info
• show.port.technology
•show.loginserver